Help center

Help center

Powered by
All collectionsLead DistributionSetting up a campaign

Setting up a campaign

A campaign is one product line, such as Boilers (UK). It holds its forms, the suppliers allowed to send leads, the duplicate rules and quarantine.

Create the campaign

In Lead Distribution, open Campaigns and create a New campaign. Give it a Name, for example Boilers (UK). Then set up the sections below on the campaign's page and save.

Forms

New leads from these forms come into the campaign. A form can feed one campaign; use Move form to switch it. A/B test variants follow their form.

Suppliers

Suppliers are your traffic sources, such as Facebook Ads, and are shared by all your campaigns. Add them in the Suppliers tab with a Name and their Source (utm_source). A lead is matched to a supplier by its utm_source, and a campaign only accepts a lead with a utm_source from the enabled suppliers ticked on it. Leads with no utm_source are accepted too. A new supplier starts ticked on every campaign; untick it in a campaign's settings to stop its leads there.

Campaign settings

  • Status: Active, or Closed. A closed campaign rejects every new lead.

  • Timezone: used for buyers' opening hours and quarantine release times.

Duplicates

Reject a lead when the same person already came into this campaign recently. Tick what to Match on (phone, email or both) and set Within (days). A lead is a duplicate when any ticked field matches a lead from that period. Rejected leads do not count, and a blank field never matches.

Quarantine

Good leads that no buyer can take right now wait here and are offered again later. Choose Which leads wait:

  • Off: no new lead waits; a lead nobody takes is marked Unsold.

  • Skipped: when no buyer could take it (caps, opening hours, rules). Example: every buyer is closed at 9pm, so the lead waits until morning.

  • Unsold: when a buyer was offered it but did not take it. Example: a buyer's sheet cannot be reached, so the lead waits and is retried.

  • Skipped or unsold: both of those.

Then set the Release: Never (leads wait until you release them by hand), After a delay, or At a set time on chosen days. Choose how many leads to release at a time and how often (Release up to, Every minutes), and Stop retrying after a number of tries: then the lead is marked Dead.

Did this answer your question?
😞
😐
😁